Cleaning the washing machine with White

Cleaning the washing machine with White Constant contact with water and detergents does not keep the washing machine perfectly clean. On the contrary, hair, lint, dirt and scale constantly accumulate inside it. Without proper and timely cleaning, all the impurities hidden in the depths of the unit will lead to an unpleasant odor, dampness, mold, even blockages, jamming and failure of the device. Therefore, once every six months, housewives should carry out cleaning, for which it is not necessary to buy expensive special equipment. If used correctly, you can ideally clean your automatic washing machine with White.

Cleaning procedure

Whiteness is accessible, cheap and versatile, so it is likely that it is available in every home. It is used for disinfecting surfaces, bleaching things and deep cleaning units, including washing machines.. The main thing is to correctly calculate the dosage of the product.

The average cost of 1 liter of whiteness is $0.2.

But it is not recommended to independently experiment with familiar whites without proper knowledge - this product is very aggressive and belongs to professional cleaners. But you shouldn’t be afraid of the “strong” composition and pungent chemical smell either, you just need to learn how to use it correctly. To avoid mistakes, we follow the instructions.

We find 1 liter of high-quality white.
Check to see if there are any items left in the washing drum. We remember that items washed with white will deteriorate and become unsuitable for further wear.
Close the hatch door tightly and turn on the machine.
Open the tray and slowly pour a liter of white into the compartments.
We start the machine by selecting a program with a heating temperature of at least 90 degrees.
We wait 10-15 minutes and touch the glass of the hatch door. If it gets very hot, then we pause the cycle or cancel the program completely.
Leave the machine with white for 1-2 hours.
After 1-2 hours, continue the paused program or select “Drain”.
After the water has drained, turn on the “Rinse” mode.
Open the powder receptacle and pour table vinegar into the compartment intended for the air conditioner (up to the “max” mark).
Start the quick wash mode.
Rinse the machine at least 2 more times.

There is an opinion that Whiteness concentrate can harm the machine, especially in those places where there are rubber seals. But the aggressive effect of the cleaner on the washing machine has not been proven - these are more speculations that force people to buy expensive brands instead of cheap liquids.

Why does dirt accumulate inside?

In fact, it doesn’t matter which product to choose - an expensive professional cleaner or ordinary whiteness. The main thing is not to leave the matter of cleaning the washing machine to chance, relying on constant contact with water and frequent washing using high-quality powders. Remember that in this way the dirt deposited on the walls of the drum, motor shaft, heating element, pipes, hoses and pump is not washed away, but is only supplemented with new “neighbors”. The machine gets dirty in many ways.

Old or woolen underwear. Imagine how much lint falls off the clothes during the washing and spinning process and begins to “walk” around the machine.
Foreign objects. Housewives often throw clothes into the drum without checking their pockets for small change or pieces of paper and without shaking off hair and animal fur.In vain, since all these, at first glance, harmless objects thoroughly clog the insides of the unit.
Hard water. In most cases, tap water contains many impurities that settle on the internal components and parts of the machine, creating a layer of scale.
Violations of operating rules. Lack of ventilation of the drum after washing, reluctance to dry the machine from moisture, storing dirty things in the tank, careless loading and unloading - all this leads to the appearance of mold and the growth of bacteria.
Poor quality detergents. Not everyone pays attention to the composition of the powder or washing gel poured in, while poor quality mixtures leave a dangerous coating on the inside of the machine. The dosage is also important, since exceeding the proportions is fraught with unwashed chemicals remaining in the machine.

Unfortunately, a person cannot avoid all existing problems. However, most of the ways in which dirt appears and spreads can be avoided. For example, if you follow these recommendations:

wash at a temperature not exceeding 60 degrees;
do not skimp on quality detergents;
soften water with special softeners;
install a special filter on the machine;
Clean the washing machine at least once every 6-12 months.

It is necessary to monitor not only the internal condition of the machine, but also be sure to take care of the external surfaces. Thus, manufacturers recommend that after each wash, rinse the drum and tray, feel and dry the hatch cuff, and on vertical machines do not forget about the rubber door latches.

It is important to keep the washer open for as long as possible to ensure free air conditioning.

What if you refuse internal cleaning?

There is no point in abandoning the simple procedure of cleaning the machine using whitewash - failure to regularly monitor the condition of the machine will lead to unpleasant consequences. The average service life of 7-10 years measured by the manufacturer will be greatly reduced if the required operating conditions of the unit are violated. Due to a thick layer of scale (even 1 mm), rapidly spreading mold, soap and grease deposits, the washing machine will not last even 2 years. More specifically, lack of proper care will result in problems. Without cleaning, the machine will become overgrown with mold.

Dirt will begin to accumulate on the walls of the hose and pipes, which will eventually clog the drain system and block the pump impeller.
A layer of scale forms on the heating element, which will increase over time and cover the entire heater. Due to such a shell, the heating element will overheat and break.
At the “entrance” to the washing machine - the place where the inlet hose and filter are connected - particles of sand, rust and scale will accumulate, which will lead to blockages and leaks.

The listed faults are only the first problematic “swallows”. These are the problems that users encounter most often. But the most unpleasant thing is that the breakdown will occur suddenly: a stop in the middle of the cycle, an unfinished spin cycle, or a non-draining process. Correcting the situation will be difficult and expensive; it is much easier to remember to rinse the machine with white.

You can avoid troublesome repairs not only with whitewash or other similar means. Many service departments offer preventative cleaning for a reasonable fee, and if you do not want or have the opportunity to work on the machine yourself, it is better to turn to professionals.

Whiteness can do a lot, and it’s quite easy to completely clean your washing machine. The main thing is to correctly calculate the ratio of water and bleach and not neglect the mentioned recommendations for caring for the machine.