Do I need to shut off the tap for supplying water to the washing machine after washing?

Many users ask themselves: is it necessary to shut off the water when the washer has finished its work? Of course, most people never do this, but it can lead to serious consequences. In the article we will try to figure out what's what.

Overlap or not overlap?

Why is it necessary to turn off the tap to supply water to the machine? After all, this is even written in the instruction manual. But because the inlet valve, which supplies water to the machine and stops it, is not eternal. It is designed for temporary use, and not for permanent use. Therefore, if the valve is constantly under pressure, it is likely that:

• the locking spring will weaken, and this will affect the tightness of the membrane:
• the rubber gasket of the valve from constant tension can wear out, which will lead to a powerful breakthrough and flooding of neighbors.

A locking spring is a device that instantly responds to a pressure drop in the tube. The situation is complicated, as a rule, by the fact that the valves fail more often at night from higher pressure and catch the owners of the machine by surprise. Therefore, make it a rule to stop serving at least when you go to bed or leave home to avoid surprises.

Attention! Manufacturers of washing machines are not responsible for a valve malfunction if the water supply was not interrupted during a breakdown.

What to do if getting to the crane is difficult? It can be hidden between the machine and the wall or disguised in a closet. Constantly moving the unit is not an option, because it is physically difficult and takes some time. Better of course to keep the crane in sight. For example, you can move the car a little away from communications, so that cranes and wires are not very conspicuous, but they can be easily reached.

Yes, valve failure is a matter of chance. It happened that the part served for ten years without shutting off the water supply after washing, and it happened that, following all the recommendations, it failed six months later.

Aquastop - salvation from flooding

What is the Aquastop system in the washing machine? This is a special optional hose that is already integrated into the washing machine. Unlike a standard water supply system withstanding 10 bar, it can withstand up to 70. In addition, the system is equipped with a special solenoid valve, which, when leaking, instantly shuts off the water supply to the machine. Moreover, Aquastop works even during washing, so you do not have to urgently try to turn off the tap to supply water to the washing machine, the valve will do it for you.

How it works? The machine with the Aquastop system also has a special pallet located deep inside. When water accumulates there, a sensor is triggered, which gives the valve a signal to stop pumping water.

In addition, Aquastop can stop the flow of water even if you go too far with detergent. But why? The fact is that with the contact of the product and water, foam is formed. And in large quantities, it will overfill the tank and begin to quickly go outside, risking damage to the electronics.

However, one should not constantly rely on Aquastop. After all, any system has costs and can misfire. It’s better to follow all the recommendations for the operation of the machine. To the question “block or not block the tap” - the answer is obvious. With detergents, as you can see, overdoing is also not worth it, it can end badly for your machine. Yes, there are times when the hose breaks through for no apparent reason due to manufacturing defects or something else. But you can only claim a guarantee if you have followed all the rules for shutting off water.