Instructions for washing machine Indesit WIUN 102

If you are reading this article, it means that you have an Indesit WIUN 102 washing machine, the instructions for which were lost for some reason. Even if you don’t want to look for it, just read the shortened version of this instruction in this article, and you will find answers to your questions. Let's start in order.

Unpacking and connection

Installation of the washing machine and its operation begins with unpacking. Whether on a new or used washing machine, you need to remove the shipping bolts. It is impossible to transport equipment without them, since moving elements may fail. So, after removing the packaging, you need to unscrew these bolts from the back and close the holes with plastic plugs.

Next, the machine must be placed on a pre-leveled floor, in a place where communications and a grounded outlet are located at a distance of no more than 1.5 m, follow these steps:

1. Place the car closer to the place where you will park it, take the inlet hose. Screw its curved end to the outlet of the washing machine.

Don't forget to put a rubber gasket at the connection between the hose and the tube for a more airtight connection. Screw the fitting washer on by hand without over-tightening it.

2. Straighten the drain hose and, if necessary, use the latch on the rear wall to secure the upper drain point at a height of 65-100 cm.
3. Push the machine into the niche or under the countertop where it will be located, leaving a gap of at least 1.5 cm between the side walls and other objects. Leave 5-7 cm at the back so as not to crush the hoses.
4. Route the hoses to the water supply and drain.Connect the inlet hose to cold water, and the drain hose to the outlet in the siphon, securing it with a clamp.
5. When pushing the machine in, do not forget about the power cord, which must be pulled out from the back of the machine and connected to an outlet. Extensions and tees cannot be used in this case, but a voltage stabilizer, on the contrary, is recommended. Although you can do without it.

When connecting a washing machine, it is not allowed to extend the drain and inlet hoses to a length of more than 1.5 meters. If extension is necessary, you must contact a service center; under no circumstances use used hoses. Violation of any of the connection requirements is fraught with consequences, and the manufacturer is not responsible, even if the machine is under warranty.

Detergent dispenser

After connecting the machine, before starting it for the first time, which, by the way, must be done at high temperature and without laundry, study its main elements. Start with the detergent dispenser, that is, the tray. IN cwashing machine Indesit of this model it is divided into three stationary compartments:

• the leftmost compartment is needed for products used for pre-soaking;
• the next compartment is used for the main wash;
• The compartment on the far right is needed for air conditioners.

In addition, there is a fourth compartment, which is inserted into the compartment on the left and is intended for bleaches. Use only when necessary; if you are not going to bleach your laundry, then it is better to remove this container.

Starting the wash

The wash is started through a mechanical control panel, on which there are 5 buttons and 2 rotary knobs. To run the program, you need:

1. Plug in the machine and remember to open the water tap.
2. Press the power button (first button on the right).
3. Load laundry, close the drum and add detergent.
4. Turn the program selection knob clockwise to the desired program, the decoding of which you can see on the detergent dispenser.
   

   For the Indesit WIUN 102 washing machine, the instructions provide a detailed description of all 11 programs, if you are interested, you can download it from the link below.

5. Turn the temperature selection knob to the desired value.
6. Press the start button.

Of the additional functions this washing machine has only:

• “Easy ironing” – provides for stopping the program with water in the drum, is not used with the “Bleaching” function, as well as for the programs: “Intensive wash” and “Everyday wash 30 minutes”;
• Reducing the spin speed;
• Bleaching – used for all programs except “Wool”, “Silk” and “Everyday wash 30 min”.

Service

When exploiting your “home assistant”, do not forget to take care of her. After washing, be sure to wipe it using a dry cloth; if necessary, you can first wipe it with a cloth soaked in soapy water, but no cleaning agents. Wipe off any drops from the control panel, be sure to wipe the rubber cuff and drum, and pay attention to the glass.

Then remove the powder tray by carefully lifting it and pulling it towards you. Wipe down the area under the tray, and then wash the tray itself. Return it to its place, but do not close it completely, let it ventilate so that mold does not form; by the way, also keep the door ajar. Once every six months, wash the drain filter located at the bottom of the washer.

Important! After finishing washing, turn off the machine from the network and turn off the water, this way you will protect the equipment from power surges and pump breakdown.

No matter how carefully you treat your equipment, it can break.The Indesit machine is no exception. To understand what to do, download the instructions for the Indesit WIUN 102 washing machine, which contains fault interpretation table. Perhaps you can handle everything yourself. Good luck!

View full instructions

Reader comments

• Share your opinion - leave a comment