How to make biscorn? It is necessary to note several stages of this work:
1. We select two schemes for the product (they can easily be found on the Internet or even drawn with your own hands). The size of the patterns depends on the desired result at the end of the work: the less you need a souvenir, the smaller the pattern for embroidery. Both circuits must be of equal size.
2. We select a floss and / or beads for embroidery. Cut off the desired piece of canvas and mark it with thread or a washable marker for fabric (in no case with a felt-tip pen, pen or ordinary pencil - then you will not wash it off). The size of the section of the canvas should be such that on all four sides of the marking of each of the two schemes, another 5-10 rows of canvas are left.
3. We embroider the pattern on the canvas according to the selected pattern.
4. We retreat one or three rows from the edges of the pattern and make a backing marking (seam “back to the needle”).
5. Next, proceed to stitching the embroidered pieces. To do this, you need to determine the middle of either side of one of the pieces of the canvas and connect it to any angle of the other piece of canvas. Then we pass the thread into the subsequent loops of trimming. So we go around the entire perimeter.
6. At the end, leave a little uncrosslinked space and turn the product on the front side, fill it with filler (cotton, hollofiber, synthetic winterizer). Sew the sides to the biscuit to the end.
7. We make the pads. To do this, pierce the pillow exactly in the center with a needle and thread the thread (you can use a bead or a button). On the other hand, the needle should exit just exactly in the center. We tighten as tightly as possible and fix.
Everything, the work is completed, the biscuit is ready! You can, if desired, sew the brushes to the corners or insert a loop handle.
