DIY do it yourself
Master classes, instructions, useful tips, recipes.
» » »How to bend a plastic pipe
How to bend a plastic pipe

For turning or bending the axis of the pipeline, a certain type of fittings is usually used - angles with a standard angle of rotation of 30, 45 and 90 degrees. But they may not always be at hand, and they are expensive (50-75% of the total costs).
Sometimes, to ensure the required angle of rotation, several fittings are necessary, which complicates installation, complicates the design and, most importantly, the reliability of the pipeline decreases due to an increase in joints.
How to bend a plastic pipe

In such cases, a way out of the situation may be to bend the plastic pipe itself to the required angle. However, for this you need to know how to do it correctly so that the bend is extremely reliable and tight.

Bending Construction Hair Dryer


In order to bend the pipe with a building hair dryer, you need to have some experience in such a business. This method requires strict observance of the heating temperature of the bent section. It should be at least 140 degrees Celsius and not more than 170 degrees Celsius.
If the temperature regime is less than the lower threshold, it is difficult to provide the necessary radius of rotation, and possible loss of shape and flattening of the product. To avoid such defects, finely dispersed filler should be poured into the pipe before heating: ordinary sand or table salt.
How to bend a plastic pipe

When the pipe overheats, the polymer begins to melt, and it becomes unsuitable for further use. It is experience that allows you to “feel” the temperature and keep it in the range from 140 to 170 degrees Celsius.

Heated sand bend


Since a building hair dryer is a special type of tool that is usually used by professional craftsmen, not every owner may have it available.
In its absence, you can use the alternative version, which ensures the bending of the plastic pipe to the desired angle, without using this thermal device. For this method, it is also necessary to stock up on sand or salt. The finely divided filler is heated on a baking sheet or simply in a metal bucket on an electric or gas stove to a temperature slightly above 140 degrees Celsius.
How to bend a plastic pipe

Then, the calcined filler is poured through the funnel into the pipe, while the lower end of the pipe is sealed with tape or closed with a cork.
How to bend a plastic pipe

How to bend a plastic pipe

The same must be done with the upper end after the backfill.
How to bend a plastic pipe

After holding for several minutes, the pipe material softens and bends easily without changing its cross section.
How to bend a plastic pipe

How to bend a plastic pipe

How to bend a plastic pipe

If after that, fix it in the desired position and maintain until the filler cools completely, then the product will be fixed in the position that was originally given to it. All that remains is to remove the adhesive tape or plug and pour the cooled sand or salt from the bent pipe.
How to bend a plastic pipe

This method, unlike thermal heating with a building hair dryer, does not require constant temperature control: it is set by the initial heating of sand or salt and then only slowly decreases. This mode most of all ensures the quality and reliability of the bend.
How to bend a plastic pipe

Bending plastic pipes using a heated finely divided composition has unlimited possibilities: a polymer product can be bent to any angle, given the desired shape not only in one plane, but also perform three-dimensional (three-dimensional) bending, for example, in the form of a spiral.

Watch the video


come back
Comments (1)
  1. Akril
    #1 Akril Guests April 7, 2019 18:16
    1
    The first time I hear that there was a real need to bend PVC pipes, all plumbing is based on fittings, but the experiment is clearly interesting, and especially when the girl talks about it (in the video))

Read also

Error codes for washing machines