DIY do it yourself
Master classes, instructions, useful tips, recipes.
» »LED flowers


From completely affordable materials, you can make LED flowers
We will need:

1) Plastic (mostly green) two liter bottles of lemonade

2) Copper varnished wire with a diameter of about 0.7 mm (can be replaced with twisted pair wires, but the effect is much worse)

3) 5 mm LEDs are transparent, green

4) Second glue

5) Soldering iron


We cut leaves from the bottle and draw veins on them with a hot soldering iron


glue the LED to the sheet with second glue


twist the wire like this


solder the LED to the wire to get such a module


From the modules you can collect flowers of any complexity, twisting them together to obtain the effect of a branch trunk. It is better to connect the modules in 3 in series and set the resistor to 200 Ohms when connected to a 12 volt power supply. The flower bud itself is made in a similar way, in order to get the effect of rose petals, you need to hold for several seconds the petals cut from a plastic bottle above the candle so that they melt a little around the edges.




come back
Comments (3)
  1. NOTFRONT
    #1 NOTFRONT Guests October 24, 2011 14:16
    0
    yes, cheap and cheerful .... 5+
  2. K2
    #2 K2 Guests October 26, 2011 17:00
    0
    Super! Beautiful and original!
  3. zheka
    #3 zheka Guests January 7, 2013 16:15
    0
    and the trunk of which is also made of copper wire? : belay:

Read also

Error codes for washing machines