DIY do it yourself
Master classes, instructions, useful tips, recipes.
» » » »Rocking chair for mobile phone
Hello!

Here is such a homemade product. Rocking chair for mobile phone.
A second use case is possible - as a card holder.


The execution is very simple.


Material - a furniture board, or plywood, or just a piece of board. PVA. A pair of clamps.
1 The sides of the chair are quarters of a circle, radius 96 mm. We cut it out with a jigsaw or a hacksaw and trim it with a block of sandpaper.
2 The back of the chair is a 100 by 55 rectangle.
3 The seat of the chair is again a 50 by 55 rectangle. (55 mm is the width of a small nokia. If you need to make a smartphone, you need 65)
4 Cut from the board, grind, mill.
5 Glue the back and seat.
6 Optional - after gluing, it would be nice to align the joint from the bottom between the seat and the back with sandpaper - so that there is no unpleasant step-roughness.
7 Then we glue the sides of the chair.
8 Optional - varnish
9 And also optionally - drill a hole for the charging connector so that the phone can be charged while lying in the chair. In the photographed copy, there is such a hole, it is in the seat under the phone.


All :)

come back
Comments (3)
  1. CYRAX
    #1 CYRAX Guests March 3, 2011 21:03
    0
    Useless thing
  2. Zmey1982
    #2 Zmey1982 Guests March 3, 2012 00:45
    0
    Can’t you lay out a drawing?
  3. Sniper
    #3 Sniper Guests November 27, 2012 09:33
    0
    Drawing is needed

Read also

Error codes for washing machines