Materials and tools:
- - foamiran pink, cinnamon, green;
- - scissors;
- - wooden stick or toothpick;
- - gerbera petal pattern;
- - gerbera wire;
- - tape tape;
- - mold, e.g. poppy;
- - glue moment second;
- - glue gun;
- - oil pastel yellow, red, carmine, green;
- - acrylic yellow paint;
- - iron.
Description
We cut out a strip of 1x20 cm from brown foamiran, turn it into a fringe.
From pink foamiran we cut out one strip of 1.3x15 cm, cut a fringe, like a brown one. We cut off the second pink strip a little wider and longer - 1.5x18 cm, cut it with teeth. Do not be afraid to make the strips longer; excess can always be cut off. But if not enough, then you have to cut the missing length.
On thick cardboard, draw a petal 1.5 cm wide and 5 cm long. Cut out. This petal of cardboard is applied to the foamiran, we circle around with a light click on the toothpick. The number of petals should be approximately 41-50 pieces. Then we cut out small petals, the width of which is not important, and the height varies from 1.7 to 2 cm. At the tips of all the petals, regardless of size, cut the corners so that a small denticle is obtained.
The tips of the pink fringe are stained with yellow pastel (on both sides). Red pastel tinted in separate sections of a pink strip of cloves (on both sides), the edges of small petals and on large petals we draw one or two rays emanating from the base (on one side).
Cut the desired length of wire.
We wrap it with tape tape.
Using the second glue, we fix the beginning of the brown strip to the wire and begin twisting, do not forget to grease with glue.
Apply a brown center to the heated iron. Then we lean against the side so that the chopped ends bend from the center.
We process thin strips by simply applying it to the iron for 2-3 seconds. The strip from the clove can be wiped between the fingers after heating. We heat small petals and rub between the fingers. The shape of large petals is attached using the mold. First we heat the petal, apply it to the mold, press with our fingers. Stripes are printed on the petals, which replace the veins of fresh flowers. If you do not have a suitable mold, then you can draw streaks with a toothpick by drawing along a heated petal.
Glue the strip, which was tinted with yellow pastel. It is enough for two rows.
We continue the formation of the lush center with the next strip of cloves.
We glue the little ones - small petals. We tint a brown heart with yellow pastel.
Glue the next 10 petals between the petals of the first row. We glue the remaining petals at our discretion, filling in the free gaps.
The gerbera splendor will depend on the number of petals.
To give juiciness to the center and imitate pollen, we paint the brown tips with yellow acrylic paint. Strengthen the yellowness of the petals, which are located after the brown center.
From green Thomas we cut out three sizes of sepals.
Heat on the iron, fold and wipe between the fingers.
Fill the gerbera base with liquid glue.
Glue the largest sepal detail.
Next we add the part to a smaller size. Green pastel shade the petals from the wrong side of the flower.
Pastel carmine color tinted petals around the brown center.
