Materials
What do we need from the materials? Only a piece of plastic pipe.
We take this piece and mark with a permanent marker the location of the cut and drilling.
Manufacture
I roughly calculated how many wires would go through and took the number of holes and grooves in stock.
First of all, cut the pipe of the right size. Saw off not a smooth edge. We clean the file with burrs and bumps. After that, we drill holes with a wide drill. Cases a full-length section of the pipe.
Now, using a heating device, in my case a gas burner, it is necessary to heat the edge of the pipe along the entire plane and bend it. See the photo.
After cooling the pipe, cut the grooves. You can do this with a small jigsaw, an electric saw, or like me with a piece of canvas from a hacksaw.
As all cuts are made, we heat each groove in turn and bend. This is done so that wires can be inserted in the future without unnecessary effort.
We clean burrs and irregularities using a scalpel, a file.
The organizer is ready for this.
Organizer Mount
The organizer for wires is fastened with two screws to the table like mine. To prevent cracking, we drill holes in the organizer and the table at the attachment point. Once screwed - everything is ready, you can insert the wires.
Conclusion
The thing is certainly very necessary. Even the mouse wire does not have to be pulled during operation - it is fixed and does not fall to the bottom. Now you can safely wash the floors under the tables and not get confused in this heap of wires.
I naturally recommend that everyone adopt my example and make their own organizer and make their life easier.
