To create an ornament, take:
- - a cord of black color (about 2 m long);
- - yellow cord (about 1 m long);
- - a lighter;
- - scissors;
- - bracelet mount.
First, cut off about 40 cm from the black cord. Fix the cord on one half of the mount as follows.
At this stage, you need to determine the length of the bracelet and adjust the cord, securing it to the second half of the clasp.
Cut off the free ends of the cord to the desired length, melt and connect.
Now we can proceed directly to weaving. To do this, take a black cord and hold it under the central base of the future bracelet.
We execute the first node. To do this, throw the right tip of the cord to the left.
The left end must be held under the central base and brought out through the right loop.
Tighten the cord.
We begin to execute the second node. It needs to start from the other end of the cord. If before that we started from the right, now now we first throw the left end.
We introduce the yellow cord. It must be folded in half, and then pass the tips through the loose black knot.
The drawn ends of the yellow cord are crossed.
After that we execute the node.
For subsequent weaving, the yellow cord must be brought out. After that we make a knot from a black cord.
Now we will repeat the previous steps of weaving. First, fold the black cord for the knot.
Then we introduce the crossed yellow cord.
Tighten the knot.
On the front side should get such a pattern.
On the reverse side, our bracelet will look as follows.
We complete the weaving by fully forming a cross.
We cut off the excess ends, and then gently fuse with a lighter.
Our bracelet "X" from the cords is ready.