How to make an Oreo keychain with your own hands

Do you like Oreo cookies? If you like, then let's make a keychain - Oreo cookies. It has many advantages: such cookies will always be with you, it will not go bad. It can also be hooked onto a backpack, pencil case or bag. But he has only one drawback, it is impossible to eat because it is made of polymer clay.

To make Oreo cookies, we need: No! Not flour and not butter, but just a little polymer clay and a good mood!

• - polymer clay (brown and white);
  
• - one real Oreo cookie;
  
• - silicone sealant;
  
• - scissors;
  
• - a wire and a fastener - a carbine for a keychain;
  
• - potato or corn starch.

Step 1. Prepare the workplace in advance, i.e. put a sheet or newspaper on the table. Let's make the Oreo cookie mold. (Mold is a mold with which you can make figures and volumetric compositions). Combine starch and silicone sealant (1: 1). It is necessary that the mass was like a dough. Also, it should not stick to the hands and get homogeneous. Roll the ball.


Step 2. Then take the real Oreo cookies, separate one half from the other and take the part of the cookie that has a clearer picture, ie cookies should not be broken and cracked. Put the cookies on a flat surface and on top of it press the same ball (from starch and silicone sealant). Cookies should be carefully covered with this mass on all sides. Leave it all to freeze. Silicone sealants have different curing times, so look at the packaging of the sealant you are using.

Step 3. After our mold has frozen, the cookies can be removed. Of course, the cookies you used to eat can no longer be! After this, it is better to rinse the mold with water.

Step 4. We take polymer clay of brown and white color. Roll two identical balls from brown clay, and one from white clay, but smaller.

Step 5. Take one brown ball and push it into the mold.

Step 6. Carefully get it, you get one half of the Oreo cookies. We do, in this way, two halves.

Step 7. Then we take a white ball and roll it. It should be slightly smaller than cookies (this will be the filling). Between the two halves we put the filling. Press lightly without damaging the structure of the Oreo pattern.



Step 8. It remains to make a hole in the cookie for the keychain. We bake, look at the temperature and baking time on the packaging of the polymer clay from which you sculpt. Then it remains to make a mount. Make a ring from the wire, insert the clasp there - the carabiner for the keychain and you're done!

We made such a wonderful cookie, it cannot be distinguished from the present! It can be used as a practical joke or given to someone.