For work we will use:
- Chiffon fabric "Brown Chameleon" and nylon brown.
- a pack of instant gelatin.
- scissors.
- lighter.
- wire.
- foil.
- glue gun.
- the rim.
- tape for the rim.
- beads on a fishing line for decoration.
- artificial twig with red leaves.
- a strip of corrugated green paper.
Before work, the fabric should be soaked in gelatin. We dilute the powder according to the instructions on the bundle, hang the fabric in one layer and give time for drying. You can speed up this process with a hairdryer. Then you should prepare templates for the petals. They are in the form of droplets, only of different sizes. We will use 6, 5 and 4 cm squares for this. All the petals should then be cut from chiffon. Patterns should be placed on the fabric at 45 degrees from the shared thread. And we will need 15 large-sized petals, 13 medium pieces and 12 blanks in a small pattern. Then from the brown kapron you need to cut 6 more leaves from rectangles of 4x2 cm. And 9 drops from 3 cm squares.
Additionally, 3 circles are needed, with a diameter of 5 cm. From them, sharp angles should be cut out in an arbitrary arrangement. These will be the sepals of the flowers.
Now we proceed to the processing of thin petals. First, we make fingers in the middle of the petal with a deepening by stretching. And due to cutting parts along the oblique thread, the fabric stretches well. Then, using a lighter, we will make small waves along the wide edge of the petals. For a second we bring the flame and the warm fabric immediately bend with our fingers, movement to break.
Not the same number of waves are placed on different petals.
Now we begin to assemble a small flower. We attach a drop of foil to a wire of 7 cm, this will be the basis. The height of this workpiece is measured by a drop of brown nylon. The petal should be above the base. First to the foil with a glue gun 3 small blanks made of nylon.
We attach all 3 petals tightly to the base and take three medium and small thin petals. Large size blanks need 4 pieces.
Glue the first small petals tightly to the brown bud.
Grease the next 3 petals with glue only at the bottom of the part.
And the last 4 petals are also arranged in a circle, gluing only at the bottom of the workpiece.
A small flower is collected, but they need two pieces. The assembly of a large flower is similar, only the number of the first row will be of 6 petals. Then we take 7 medium-sized blanks.
We attach all the petals only to the lower edge. There will also be 7 large pieces.
Now the big flower is ready.
It remains only to glue the sepals from below, which we pierce with wire in the middle.
Then you need to glue the wire itself with corrugated paper.
Flowers are ready.
We pass to the leaves. First, cut the cloves along the edge of the workpieces. Then we make folds, bending the sheet, warming it with a candle and pressing it with our fingers. We make strips similar to veins.
Then cut the wire shorter, and glue the sheet to each flower from below. Lubricate the lower edge with glue and fasten around the wire with a bag.
Such flowers will be attached to the rim.
The rim itself needs to be pasted over with a thin tape. And prepare 6 bead jewelry on a fishing line.
We cut the fishing line 8 cm long and glue from the middle of the rim in different directions, along the rim, three pieces together.
Next, glue a large flower in the middle of the rim, and small on the sides of this blank. The remaining leaves are glued on the wrong side of the flowers with the rim. It is necessary that the inside looked neat.
Now take an artificial twig with leaves.
And fasten in between the flowers. The decoration is ready.
Good luck to all!
