* Two binding blanks measuring 15*15 cm;
* Fabric in mint green color with flowers, 100% cotton;
* Sintepon;
* Adhesive “Scotch tape effect”;
* Paper napkin cut from thick cardboard in white;
* Mint hollow heart mint color;
* Satin ribbon 25 mm wide, mint color;
* Picture with newlyweds;
* White fabric flower;
* Chiffon roses on a white ribbon;
*Mint cotton lace 35mm wide;
* Stamp “Happy Wedding Day”, green ink;
* Mint-colored scrap paper, sheet 30*30 cm;
* Cutting champagne and beige glasses;
* Mint large poppy;
* White latex roses and light mint roses;
* Metal brads with shiny stone;
* Curb hole punch;
* White cardboard;
* Glue stick;
* Small beige semi-pearls with a diameter of 3 mm;
* Scissors, double-sided tape, ruler, pencil, heat gun.
The first step is to connect the binding cardboard blanks together. To do this, we need to cut a strip of white cardboard or watercolor paper measuring 5.5*15 cm.We divide this blank into three parts 2.5 * 0.5 * 2.5 cm. We draw bend lines under the ruler.
Now we spread it on both sides with a glue stick and glue it onto both binding blanks. You need to press and level it well, and then carefully draw it between the workpieces with scissors.
Using strips of double-sided tape, we now need to glue the padding polyester onto the entire solid piece. Now we take the fabric, place the prepared cover on it and apply it. On all sides you need to make a margin of 1.5-2 cm around the perimeter.
We smooth the fabric.
Fold the blank in half and glue a napkin onto the fabric, tint the edges of the picture and the inscription. We also glue them onto the napkin and below the napkin.
We sew them on by machine. We insert brads into the flower.
Now we place the front side of the fabric on the table, lay out the soft cover and wrap the fabric inside. Apply glue stick and glue. It's better to start from the corners.
Sew along the edge of the entire cover. Now let's design the cover inside. To do this we take scrap paper.
We cut out two squares of 14.7 * 14.7 cm and for pockets we cut out 8 * 14.7 cm. We go through the pockets on one side with a border hole punch. We glue the pockets onto the squares and sew both squares along the edge.
Now we glue a partition made of scrap paper inside the cover, then glue both squares with glue with the effect of adhesive tape. We place the unfolded blank under the press so that the cover is pressed well and fixed. After the cover has dried, all we have to do is glue it decor.
The result is such a beautiful and delicate envelope for wedding CDs. By the way, guests can use it as an envelope for money, and the newlyweds will use it for its intended purpose. Thank you for your attention!
