To make a Bead clamp you will need:
- clamp.
- blue tape with a width of not more than 25 mm.
- scissors.
- middle for flowers.
- lighter.
- glue gun.
- beads with a diameter of 4 mm.
Creating a Bead jewelry.
The decoration is one large flower, consisting of narrow petals with beads. To start creating this decoration you need to prepare the petals. For this, segments of a blue ribbon 9 cm long are required. In total, 19 pieces are necessary.
Exactly in the center of all segments, it is necessary to make a mark on the edge line.
To the designated mark, you need to bend the edge of the segment on the right side.
Then do the same on the left side, but be sure to make sure that the edge lines are parallel to each other.
The resulting triangular parts should be folded in half along the edge lines.
The edges held by the fingers should be trimmed with scissors and seared to fasten the tapes together.
Focusing on the fold lines running along the top, measure down 5 mm and cut off the rest of the tape. Formed sections must be immediately treated with fire for fixing.
It turns out long petals.
In total they will turn out 19 pieces.
Created parts must be combined together to form a smooth circle.
In the center of each petal, one transparent bead should be sewn, placing them closer to the edge.
The second row of beads must be sewn 5 mm further, but placing them between the petals. As a result, the petals are curved.
From the remaining amount of tape, it remains to prepare a small circle, reaching a diameter of 5 cm. Its edge must be scorched.
This item will be the basis for decoration. It must be glued to the bottom of the flower, positioning strictly in the center.
On the resulting base, you need to fix the clamp, carefully lubricating it with glue.
It remains to straighten the petals and attach the middle for the flowers, closing the center of intersection of the details.
Bead decoration is ready!
