Quite simple and nice design computer desk. Yes, of course, compared to store-bought ones, it is much cheaper and the design, if anything, can be changed however you like, to suit any interior.
Advantages of this computer corner:
The design is cheap and easy to manufacture.
You can set the tabletop to any height.
large table depth. Previously used for a CRT monitor tube.
there is room to stretch your legs (from the edge of the table to the corner 80cm).
Very efficient use of room space - does not take up much space.
The tabletop is made from a solid chipboard (600mm wide).
The corners are cut off from the original rectangle and the resulting trapezoid is attached to the wall with the corners (blue circles).
The far corner of the table is cut out of the scrap and placed on two washers screwed to the tabletop from below (green in the diagram) and a screw screwed into the wall (red). You can make a shelf from other trimmings.
A block of sockets is fixed under the tabletop.
and systems specialist
I recently added laminated chipboard shelves to the table. Strengthened it at eight corners.
Load testing of the countertop - everything is fine, it stood up to it calmly!
Load testing of a 42 kg shelf:
Cost in general:
Tabletop: 600x1600 ~700 RUR
Corners for tabletops: 4 pcs ~20 rub.
Shelves: 20x100x3 + 20x130x3 + 25x15x4 ~350 rub.
Ribbon for edging shelves: ~50 rub.
Screws and euroscrews: ~50 rub.
Corners for shelves: 100x125 ~10 pcs ~140 RUR
Total: Table and shelves: 750 + 600 = 1350 (with reserve)
PS: The system unit on the wall is the result of the fight against noise. The more massive the base, the less it resonates from the body. That's why it hangs on the wall. Ideally, it is better on a permanent wall.
