For work we take materials:
- sewing machine.
- scissors.
- acrylic paints.
- black gel pen.
- a little white dense fabric.
- a thin brush.
- a piece of foam.
- a pencil.
- coffee solution (1 tablespoon of instant coffee and PVA glue, a package of vanillin and 100 ml of warm water).
- Thin cord 30 cm long.
- filler for toys.
- essential oil of cinnamon and vanilla.
- a needle with a thread.
- an empty small medical syringe.
But before starting work, we will draw a template form of two bunnies.
Now we take the prepared fabric, fold it in half along the shared thread. It needs to be stretched in width, not in length. We apply the cut out patterns and circle with a simple pencil. And cut out with increments for seams.
We put notes for the holes through which we will fill the product.
Now we take the sewing machine and sew along the contour, leaving only the intended segments intact. After that, we cut the notches in the curved places of the patterns, so that it works well when inverted.
Now we turn out using a pencil.
We aligned all the bends and proceed to filling. To fill the hares, you can use sintepon, sintepuh, hololiber. When filling, we also use a pencil. Stuffing is not very tight.
Now, with a needle and thread, we sew up our free holes. Then on the ears of thread we make loops for drying. And with a simple pencil we outline the main arrangement of future eyes.
It's time for tinting coffee. The solution itself is not difficult to prepare. In 100 ml of not very hot water, dissolve 1 tablespoon of coffee and the same amount of PVA glue, mix well, then add a pack of vanillin. When the solution is ready, take a piece of foam and smear it with bunnies on all sides and all the seams. And hang to dry. It is possible in the air for 2 hours or in the oven for 10-15 minutes.
A certain time has passed and the products have dried. We take acrylic paints. The first one to use is brown, diluted with water and using a piece of foam rubber we tint at the seams. The drawn base for the eyes is visible and now with a pencil we continue to outline all the details of the muzzle.
When the seams are dry, take the gel black pen and draw the entire muzzle along the outlined contours.
Now take a thin brush and paint the eyes. We draw three contours, first at the bottom white, then blue and black. We put the glare-dots white on the pupil. The nose of the bunny is also painted black. Draw the white cheeks. We give time to dry.
And then we go through all the contours again with a gel pen, add the antennae points on the cheeks. All faces are ready. Now take a lace 30 cm and divide in half. Using a needle, fasten the eyelets from the back between the ears. At this coffee flavored coffee bunnies are ready. And there remained a small detail, it is a common syringe to introduce a few drops of vanilla and cinnamon into the body of the toy for flavor.
Good luck to all!
