To create a necklace you will need:
- scissors.
- a tape of a white shade, two types of width, in 5 and 2.5 cm.
- white cabochon in the amount of 5 pieces.
- lighter.
- beads on a thread with a diameter of at least 0.4 cm.
- glue thermal gun.
- contour for textile work with silver sequins.
Making a necklace.
It is necessary to cut off even billets from the roll of a wide ribbon, the sides of which should reach 5 cm, in total 25 pieces of such a necklace will be required.
Separate petals must be prepared from each square, from which flowers for the necklace will be collected.
Prepared white parts should be bent diagonally, giving them the shape of a triangle.
Now, the sides with the slices must be collected in many folds.
Using scissors, you need to remove excess uneven sections, leveling them, and immediately treating new edges with lighter fire, fastening the assembled folds of the tape.
The result is petals with a rounded apex and beautiful folds at the base.
Such petals for a necklace will need 25 pieces.
Next, prepared petals should be joined together in five pieces, fastening their bases in a circle.
The result is 5 of the same colors.
Flowers can be temporarily set aside and prepare leaflets for them. This will require a white ribbon, but with a smaller width.
From a tape 2.5 cm wide, it is necessary to make 25 segments with sides 2.5x4 cm.
The resulting blanks must be folded in half along their length.
Then cut off the corner near the edges of the tape, leaving the fold line intact.
Holding tightly folded in half parts, it is necessary to carefully scorch the edges of the cut corners, soldering two layers of the part.
Further, it remains only to turn the parts with a weld seam back to give the upper part of the leaves a pointed shape.
Created leaves need to be attached with hot glue between the petals of already prepared flowers. They should be attached in the center of the inflorescence, so that only the sharp tips of the leaves go beyond the petals.
The remaining leaves must be fixed on the remaining 4 colors.
Now you can connect the necklace. Three flowers should be glued together to form a triangle.
Then the resulting triangle must be turned down so that the two flowers are located at the top. Then, the remaining two flowers must be glued to the necklace blank, forming two branches from them to the right and left sides.
Now a segment of beads on a 55 cm long thread will be required. This length will be enough to put the jewelry over the head without adding a fastener.
The ends of the beads on the thread should be fixed to the wrong side of the colors of the two branches.
It remains only to decorate the necklace, complementing its flowers with cabochons, petals and leaves with sparkles.
The necklace is done!
