For a bouquet of roses, we need the following materials:
- pink ribbon, 2.5 cm wide and 230 cm long.
- a ribbon of white color, 2.5 cm wide and 154 cm long.
- green satin ribbon with a length of 150 cm.
-glue gun.
- for decoration: a few beads, fishing line, braid.
- flower stamens.
- lighter.
- a hairpin clip big for hair.
- a needle with a thread.
- scissors.
We start by cutting the tape. We take a pink-colored ribbon and cut it into strips 7 cm long. For one flower, 11 strips will be needed, and there will be three pink roses, respectively 33 strips in total.
We start with one rose. We take 11 strips and begin to make flower petals out of them. We burn the edges with a lighter. In each strip on the wrong side, we bend corners from two sides and fix with sewing needles.
Now we take a needle with threads, preferably in the color of the tape, and fasten along the edge where the needles were bent.
Then we tighten the thread and fix the resulting petal.
We make 11 such pieces.
Then we will collect the bud with a glue gun. It consists of 3 petals. We twist the first workpiece with a tube and fix it. Now we glue it to the middle of the second petal along the entire height, pressing the edges.
And glue the third petal, covering the free edges of the second. The bud is ready.
The second row also consists of 3 petals. We glue these blanks a little with approaching each other, arranging in a circle.
But in the third row there will be 5 petals, also with each other approaching in a spiral. The flower is ready.
And the result is three pink and two white roses.
Now you need to glue the substrate to the colors. They are green, which means we will cut from a green satin ribbon. We cut strips 6 cm long, 25 pieces. 5 pieces per rose.
We take the strip folded in half in length, with the face inward, and cut it with scissors singing, gluing the edges to each other or cut it out with a thin tip soldering iron.
We turn these 5 petals face up, we get the shape of a boat.
But on one side of the leaves, we cut off corners from 0.5 to 1 cm, we cauterize a smooth edge.
When the leaves are ready, turn the rose upside down and glue these blanks with cut sides to the middle of the bottom of the rose.
A rose with green leaves is ready.
In the same way, glue the leaves to all 5 roses.
Now we need a foundation on which we will collect our bouquet. Cut 2 circles in diameter 7 cm.
And for decoration we take a 40 cm braid and any thin fishing line 60 cm long.
Glue the tape on one circle, and cover it with the second circle, fix it with a glue gun.
We cut a thin ribbon into three strips and each fold 2 times in half, fixing with a needle.
Spread out, it turns out 2 curls.
Now take the stamens and glue them between the two blanks. And on the fishing line we glue small beads with a gap from each other.
We now proceed to assemble the bouquet. Between two white roses we glue a curl of beads.
And then we attach them to the finished base, gluing with a gun. They will be located a little backward from the middle, closer to the edge.
Now the roses are pink in color, placed next to them, on the base.
To decorate the bouquet between roses, you need to fix the stamens with curls.
It remains only to fix a large hairpin-clip on the base with roses.
Well, the hair decoration is ready.
Good luck to all.
