Homemade feeder for feeder

Feeder feeders are consumables. Sometimes when fishing in locked places, a fisherman can lose a lot of feeders in one fishing trip. But they are not so cheap. Mono of course refuse fishing in promising places, but you can greatly reduce the cost of the feeders themselves. To do this, you can do it yourself. It is not that difficult. To make a feeder feeder you will need - a plastic bottle, lead, paper clips. Of the tools you will need scissors and pliers. You will also need a nail or a soldering iron. Small scales are highly desirable. But you can do without them.



First of all, cut a strip from the bottle. We cut it in such a way that, when folding, we get a cylinder with dimensions corresponding to the size of the feeder.



Then you need to make holes in the strip. This is easily done with a heated soldering iron. If it is not, a nail heated on fire will do.



When heated, it should be held with pliers, this will reduce the risk of burns. Holes need a lot. Bait will spill out through them.



After this, a strip of lead is required. Lead is easiest to find in old car batteries. One battery is enough for many feeders. But before use, lead needs to be melted. This should be done in the open air, observing all safety precautions. To obtain strips of lead, its slice is flattened with milk to the state of the sheet and cut with ordinary scissors into the necessary strips.



The lead strip should be slightly longer than the feeder. This will fix it.



Bend the paper clip as shown in Figure 7.



After that, with the help of pliers, we collect the feeder. First, bend the edge of the strip without a paper clip. Lead must be pressed as hard as possible. Homemade feeder feeder is ready.



If there are scales, feeders can be weighed and signed with a marker. It is not necessary to make the feeder transparent. You can use bottles of different colors.