DIY do it yourself
Master classes, instructions, useful tips, recipes.
» » » »Corrugated paper rose bud
Corrugated paper has its own special properties, thanks to which you can make charming flowers out of it, which will be a great imitation of living specimens.

Corrugated Paper Rose Bud


To make such a bud, you need to work:
Material:
- thick corrugated paper in the following colors: green and pink.
- wire.
- a small ball of cotton wool.
Instruments:
- scissors.
- tweezers.

Making a flower. The first thing you need to do from a piece of pink corrugated paper is to cut a regular rectangle with 6x7 cm sides with a pair of scissors, it is important to make sure that the part is not skewed.

paper


Then you need to round the two upper corners and mark the tip pointed in the center.

Flower making


Now you should cut 15 cm from the prepared fishing line. At the obtained segment you need to take one edge and bend your finger around it, creating a small ring and freeing your hand to fix the wire in this form.

Flower making


Next to the pink part in the middle of it, you need to place a ring of wire and a small piece of cotton wool. It is needed to obtain the fullness of the bud and facilitate its creation. Now you need to use the right rounded corner to wrap the cotton and wire parts folded in the center. At the intersection of cotton and paper, you need to slightly stretch it.

Flower making


After that, you should make the same fold, but on the other side.

Flower making


Next, you need to very tightly fold the bottom of the resulting bud. To do this, it is best to twist the paper with your fingers around the wire, the stronger, the better.

Flower making


Now you can start creating leaflets. To do this, cut a large rectangle from green corrugated paper, the sides of which will be 6x9 cm.

Flower making


Further along the longest side of this part, you need to make a lot of zigzag cuts.

Flower making


After this, with prepared foliage, you need to wrap the base of the bud made. The lower part should also be tightened tightly and it is better to tighten the wire for secure fastening.

Rosebud


From the remaining piece of green paper, you need to make a straight strip 3 cm wide and about 15 cm long and wrap the wire with it. With this strip, you need to cover the base of the bud and gradually wrap the wire at an angle of 45 degrees, creating a flower stalk.

The long parts of the leaves that touch the bud, you need to carefully twist your fingers.

Corrugated Paper Rose Bud


Now the rosebud is ready. From such flowers you can make a very attractive bouquet!

Corrugated Paper Rose Bud
come back
Comments (0)

Read also

Error codes for washing machines