For such pads you will need:
-embroidery 25 * 25 cm
- small residues of different cotton fabrics,
- synthetic winterizer 45 * 45cm,
- lightning 45cm long.
First of all, you need to iron all the fabrics and embroidery. From multi-colored shreds we cut out squares 5 * 5cm. And we spread around the embroidery, as we like, in any order. Shuffle several times to make the result like.
We take 6 lower and 6 upper squares and sew them with a “caterpillar”. Sew one by one. Smooth it well off the face and inside out. You need to smooth it with a hot iron without steam! During ironing, pull the iron in one direction. There is no need to fidget here, otherwise the stitched part is deformed.
Sew the “caterpillars” to the upper and lower edges of the embroidery. Smooth it well off the face and inside out.
We sew the “caterpillars” of 8 squares on the left side and on the right. Iron well and sew to embroidery. I want to note that the ironing after each sewing step is very important! Make sure that the seam allowances are turned in one direction! Then the shreds will be even and neat.
We cut out two strips of 7 * 32 cm and sew to the "caterpillars" to the left and right of the embroidery. We iron the seams.
We cut out two strips of 7 * 42 cm and sew on top and bottom of the embroidery. We iron everything again.
We take a synthetic winterizer and a piece of any fabric measuring 45 * 45 cm. And we form a three-layer sandwich, chip it all over the field with pins, so that we stick together and quilted. You can quilted with straight lines at the joints of seams, or you can use different patterns, as in the photo. After the stitches, trim the protruding synthetic winterizer and the lower fabric. Trim, focusing on the front side, the one with embroidery. We got a face blank with dimensions of 40 * 40 cm.
Getting to the inside of the pillowcase. From the fabric we cut out two rags of 40 * 25 cm. We sew a zipper on the sides 45 cm long.
We connect the face and the inside of the pillowcase. To do this, we align these blanks with the wrong side to the wrong side and we sew a line along the perimeter along the perimeter.
Preparing a trim for edging. Cut a strip with dimensions 6 * 165cm. If there is no such long cut. Then you can connect several short strips.
The resulting long strip is folded along and ironed.
Sew the resulting bake to the wrong side of the pillowcase. To do this, we align the slices to the slices and sew on the width of the foot. We form corners.
We turn the necklace over to the face and pin it to the pillowcase with pins, we pay special attention to the corners!
Sew the necklace manually to the front of the pillowcase. It is better to use a blind seam.
Here we get such a pillowcase as a result. Face - patchwork technique with embroidery, wrong side - plain with zipper. Such a pillowcase will serve as an excellent decoration for a child.
