So, for the manufacture of such flowers, we need materials such as:
-caprona (hosiery) fabric
- threads in tone of fabric, a needle
-scissors
-sintepon
-glue
-artificial flowers
hardware eyes
-flower pot
-gypsum
-Styrofoam
First we take a synthetic winterizer, tear it in small pieces and put it into three equal piles.
Now we will cover the synthetic winterizer with kapron material, giving the shape of a not very convex ball and fix the free end of the fabric from the back with an ordinary hair elastic.
Then we take a synthetic winterizer and tear it into two small piles, one slightly larger and distribute it under the workpiece fabric. These are the future nose and cheeks of our flowers.
Now with the help of a screed we need to form the nose, cheeks, mouth and lips on the face.
We touch the needle with a more authentic thread and proceed to the firmware. We mark the approximate place of the nose bridge with our fingers and begin to tighten from right to left. Only pierce the needle at one point so that the seam is as invisible as possible.
Sew 5-6 times and bring the needle obliquely down, then up again, forming nostrils at the nose.
In the process, correct and align the shape, with a needle you can correct small irregularities, prying and fluffing the synthetic winterizer, which is inside the muzzle.
When you have finished shaping your nose, cut the thread and carefully tie it.
To tighten the cheeks and mouth, it is better to use two needles. We find the upper point of the cheek with our fingers, start the needle and withdraw obliquely. Firmly stitch to fix. We do the same with the other cheek, using a different needle.
We tie the threads together, tightening them at the same time. We tie and cut off the excess thread. Unhook the sintepon with a needle where the upper lip of the product is and, injecting the needle under the lower lip, bring it under the nose and again lower it down. We tighten the threads and cut off the excess.
We flash the places where the eyes will be glued. Sew on the back of the place that was tied with an elastic band. We cut off the excess tissue. We do the same manipulations with the rest of the workpieces. We glue the eyes (you can replace the accessories with ordinary buttons).
We take artificial flowers (you can sunflowers, daisies, roses, etc.), coat the middle with glue and glue the stocking face. Having done the same with the rest of the flowers, we take a flower pot, chopped polystyrene there and, having inserted the flowers, fill it with divorced gypsum.
The set gypsum itself can be painted with black acrylic paint or decorated with green yarn.
You can decorate with insects from beads or bows from satin ribbons. In this product for decoration I used a pop doll in hosiery, a ladybug and a dragonfly made of beads, as well as leaves and flowers made of beads too.
Making such flowers is an exciting and enjoyable experience. I wish you success and creative inspiration!
