To transform my old rim, I needed. Three colors of satin ribbons, a width of 5 centimeters, a candle, superglue, scissors, beads of two colors, accessories for jewelry - a socket, thread and a needle for beads.
To begin with, you need to prepare the material, for this I cut the tape into squares of 5 centimeters.
So that during operation, the tapes do not crumble, their edges need to be melted on fire.
The next step, I began to fold the green segments into the sharp kanzash petals, for this we fold the square into a regular triangle.
Then, the resulting triangle is bent in half.
Now we connect together its two lower corners, and, having drawn such a markup, cut off everything below. the melted corners are well melted over the candle and squeezed with your fingers so that the edges do not separate.
The lower edge only needs to be scorched, preventing shedding.
A neat hole should remain on the finished petal below.
Using this technology, we make all the remaining petals from the green ribbon - these are leaves. My project took 10 of these leaves.
Now we are going to make flower petals. They are not much more difficult to do, because the basis is still the same sharp petal of kanzashi. The main difference between flower petals and its leaves is the number of triangles.
It took me 12 squares of pink and beige. The meaning is the same, only before connecting the corners, you need to superimpose one triangle on another.
Now you can form a petal by connecting the corners and singeing the edges, giving it a finished look.
All important details are ready.
The next step is to prepare the surface on which we will mount our flower. To do this, we need a piece of cardboard, a piece of tape and glue.
Cut a strip of cardboard, which will be slightly wider than the rim. Now gently glue it with the prepared tape and singe off the excess edges.
Next, we fix the prepared base in the desired area of the rim.
Well, you can proceed to the main part of the process - to collect the flower. To do this, apply a drop of glue at the edges of the petals and glue them in this way.
To hide the scorched edges and irregularities in the middle, we fix in the center a rosette and a bead, suitable in size, using a small bead and thread.
And glue the flower to the center of our blank.
Next, we complement our work with the remaining petals and leaves in the desired order, using the same gluing technology. (photo28) And we decorate with beads, which we also sit on superglue.
The work is done.
After good drying, you can safely decorate any head with such a rim.
