DIY do it yourself
Master classes, instructions, useful tips, recipes.
paper scorpion


Children are always attracted to something unusual and mysterious. They watch movies with all sorts of monsters and monsters. But it’s better to acquaint children with the world around them not through a scary movie, but with the help of such crafts. Look how cute the scorpion is!

How to make a scorpion out of paper.
Take a piece of paper. Make a square.
Fold it diagonally.

Fold sheet diagonally


Fold the sheet so that the fold is on the right.

so that the fold is on the right


Bend the top left corner.

bend down


Turn the triangle obtained on the right with a “cap” so that the fold is turned up from the top right in the center.

expand the triangle


Turn the workpiece from left to right on the other side.

Turn over the workpiece


Expand the sheet on the right side and bend the fold to the middle.

Expand the leaflet


Iron the part.

Iron the part


Bend the corners as shown in the photo and rotate again. These are your auxiliary lines.

Bend the corners like that


Lift the bottom corner up.

Lift the bottom corner up


Bend the edges of the paper inward at the folds on the sides.

bend the edges of the paper inward


You got such a rhombus.

rhombic


Turn the workpiece over to the other side.

Turn over the workpiece


Make the same rhombus.

Make the same rhombus


Turn part of the part over like a book from right to left.

Turn over part of a part

book from right to left


Turn the lower part of the workpiece to make such a figure.

Lower part of the workpiece


The corner above is bifurcated.
Bend both sharp corners in different directions, as if twisting them.

Corner bifurcated


This is what you should get. These are future scorpion claws.

should succeed


Bend the ends of the claws up.

Claw ends bend


Expand them from the outside, making them rhombuses.

making them rhombuses


Bend the sides to the center, making markings, and then hide these edges along it inside the workpiece.

Bend the sides


Well smooth the edges, otherwise the craft will constantly unfold.

Smooth the edges well


Do the same on the reverse side.

do the back side


Turn the “face” crafts up (where the claws are). Mark with pencil or chalk.

Turn the craft over


Roll the upper part of the workpiece along with an accordion.

roll up an accordion

roll up an accordion


Flip to the other side. Make markings: one in the middle on the horizontal bend, and the other two on the sides just below.

roll up an accordion


Cut the top leaf in the middle to the center point, and on the sides to the mark. These are paws.
Bend them in different directions.

Flip to the other side


Now bend the legs in the middle up. And then at the edges.

Bend them in different directions


Bend all legs towards the head.

Now bend the legs in the middle up


Turn over the workpiece. You got such a scorpion. Lift his tail tip up. Now he is ready to attack.
come back

Read also

Error codes for washing machines

Fans with corrugated roses

An effective mosquito repellent

Laying tiles on the floor

To comment
Comments (0)